(I'm using windbg from Windows Kits\8.1\Debuggers\圆4\ as installed with VS2013).īUT when I ran windbg without arguments and applied tcp:server=10.102.25.32,port=50000 to "File/Connect to Remote Stub." and then "File/Kernel Debug." with 1394:0 then it's a SUCCESS. What's wrong here? I couldn't figure it out. + FullyQualifiedErrorId : UnexpectedToken + CategoryInfo : ParserError: (:channel:String), ParentContainsErrorRecordException PS C:\Windows\system32> windbg -k token ':channel' in expression or statement. There is problem running windbg with appropriate command line arguments: It seems that ConnectType "net" is probably not supported for kdsrv smart client, I decided to go for 1394. : EnabledĪnything I miss? Is it possble to setup network kernel debugging in my case? .Microsoft Kernel Debug Network Adapter bindings should be reset Microsoft Kernel Debug Network Adapter binding check complete Removing device WAN.
Select the driver needed and press download.
Needles to say I can't connect to the target with WinDbg.Įthernet adapter Local Area Connection* 1:ĭescription. Microsoft Kernel Debug Network Adapter - there are 5 drivers found for the selected device, which you can download from our website for free. Id rather be a failure at something I enjoy than be a success at something I hate. open it by right-clicking and choosing 'Run as adminstrator '. The kernel debug interface gets created ("Microsoft Kernel Debug Network Adapter") and I've configured it's MAC in DHCP so it should get an address. I did add a few steps to what is on the web site: go to start menu -> Run. (Yes, the network controller is one of the supported.) I've configured the target platform following strictly the instructions in: This is not exactly one LAN (there is a router between my dev machine and the lab), but otherwise it's close and FW doesn't block connections to lab machines (like telnet to port
We or the computer original equipment manufacturer (OEM) may not provide technical support for some or all issues that could arise from the usage of this generic version of software drivers.I am trying to configure network kernel debugging on a dev platform in a lab. In the Kernel Debugging dialog box, open the Nettab. To avoid any potential installation incompatibilities on your OEM system, We recommend that you check with your OEM and use the software provided via your system manufacturer.
You just leave it by itself if you dont combine Ethernet. Microsoft Kernel Debug Network Adapter Driver Windows 10 Network Adapter Driver Windows 7 Windows 8 startup proceeds, but a message box is displayed informing you that the kdnic service has failed to start. This protocol is used for Netword Interface Card bonding, which is the combining of two ethernet cards to appear as one physical device in order to increase the available bandwidth. However, computer original equipment manufacturers (OEMs) may have altered the features, incorporated customizations, or made other changes to the software or software packaging they provide. The Microsoft Network Adapter Multiplexor Protocol service is a kernel mode driver. The software drivers provided on this page are generic versions and can be used for general purposes.
System manufacturer - System Product Name Hewlett-Packard - HP Compaq nc6220 (ER512EP#UUF) This download is valid for the product(s) listed below: Uncheck the box that says Allow the computer to turn off this device to save power. Microsoft Windows Server 2008 R2 Enterprise Windows Server 2008 R2 Enterprise (Full Installation)